1/4x2-1/4 Mas-Tap Hd Anchor
(Pack of
10.0)
• One-piece heavy-duty anchor with sharp aggressive concrete cutting threads
• Easy to install and can be removed
• Serrated teeth under the head grip to installed fixtures
• Steel thread design provides a keyed engagement and allows for reduced spacing and edge distances
• Can be used in a variety of solid masonry materials such as concrete, brick, stone, and block
• Works with standard properly sized masonry drill bits, no special bit required
• Zinc-plated case hardened low carbon steel
1. Check specs to determine proper anchor.
2. Drill hole to proper depth. Then remove dust and debris.
3. Place anchor through fixture and into hole and begin tightening.
4. Tighten until anchor head is tightly seated against fixture.
Couldn't load pickup availability
California Proposition 65: Not Applicable
www.P65Warnings.ca.gov
Frequently Bought Together
Masonry Anchor Hex Washer Head Steel 5/16 x 1-3/4"
Couldn't load pickup availability
Masonry Anchor Phillips Head #14-10 x 2-1/4"
Couldn't load pickup availability
Lag Screw Shield Anchor Long Style 3/8 x 2-1/2"
Couldn't load pickup availability
Diamond Grip II Installation Kit 5/16-24
Couldn't load pickup availability
Diamond Grip II Installation Kit #8-32
Couldn't load pickup availability
Diamond Grip II Installation Kit M10-1.5
Couldn't load pickup availability
Masonry Anchor Hex Washer Head Steel 1/4 x 3-3/4"
Couldn't load pickup availability
5/8x4 Mas-Tap Hd Anchor
Couldn't load pickup availability
1/4x3 Mas-Tap Hd Anchor
Couldn't load pickup availability
Female Terminal for GM Vehicle 12-10 AWG
Couldn't load pickup availability
Female Terminal for GM Vehicle 16-14 AWG Unsealed
Couldn't load pickup availability
GM Wire Loom Routing Clip 11/32" Black Nylon
Couldn't load pickup availability
Product Description
• One-piece heavy-duty anchor with sharp aggressive concrete cutting threads• Easy to install and can be removed
• Serrated teeth under the head grip to installed fixtures
• Steel thread design provides a keyed engagement and allows for reduced spacing and edge distances
• Can be used in a variety of solid masonry materials such as concrete, brick, stone, and block
• Works with standard properly sized masonry drill bits, no special bit required
• Zinc-plated case hardened low carbon steel
1. Check specs to determine proper anchor.
2. Drill hole to proper depth. Then remove dust and debris.
3. Place anchor through fixture and into hole and begin tightening.
4. Tighten until anchor head is tightly seated against fixture.
Technical Specifications
| Item#: | DY09991346 |
|---|---|
| Diameter | 1/4 " |
| Length | 2-1/4 " |
| Type | Screw Anchor |
| Material | Carbon Steel |
| Minimum Embedment | 1 " |
| Finish | Zinc |
| Drive | 7/16 " |
| Drill Size | 1/4 " |
| Head Style | Hex |
| Drive Style | 7/16 " |
| Minimum Hole Depth | 1-3/8 " |
| UNSPSC #: | 31162104 |
| TAA Compliant: | Yes |
Product Restrictions
California Proposition 65: Not Applicable
www.P65Warnings.ca.gov
